Enable-IT 860 Series Manual de usuario descargar pdf (Pagina 12)



 Switch 3: 17a (over 1,500ft) / 30a (under 1,500ft) Mode

17a Mode – Up / Off Position

30a Mode – Down / On Position (Default)

17a mode is only used for Interlink runs over 1,500ft to 6,000ft.

30a mode is only enabled for Interlink runs under 1,500ft.

 Switch 4: Signal-to-noise Noise Ratio (SNR)

9dB – Up / Off Position

6dB – Down / On Position (Default)

Signal-to-noise ratio is a measurement that refers to how much noise is in the output of a

device, in relation to the signal level. If you experience issues of noise bleeding over the

lines, or high interference in your environment, it is suggested that you switch to 6dB

SNR. This may help clean up any noise bleeding over your cabling.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Enable-IT 860 Series Manual de usuario Pagina 12